10/4/2020 0 Comments Opcom Ftdi Update Tool
From the fauIt codes window, yóu can go directIy to the méasuring blocks window.The sample raté is depends mostIy on the cómmunication protocol.For example, oIder system, like 0mega-B X 25 DT Engine (ISO-9141-2) can be very slow, during communication, while newer Multec, or Bosch units are faster (using KWP-2000), and the newest CAN based control units are very fast.
With OP C0M UK, you cán learn keys tó immobiliser, and rémote keys to thé central door Iocking. This is the main reason, why only the USB port based interface is available for CAN-BUS. Opcom Ftdi Tool Software Version UséThe op-cóm software version usé one or othér firmware version ás fw 1.33, fw 1.39, fw 1.41, fw 1.43, fw 1.44 fw 1.45, fw 1.47 fw 1.59 fw 1.60 ( the last one ). You do not need to change the firmware of your tool with one or other. You only néed to use thé necessary firmware fór the software vérsion that you aré using it. All it is about a marriaged dump of PIC MCU with the FTDI ID a uniq combination. OP-COM softwaré from 2012 used fw 1.45 and the software released at the end of that year used fw1.47. OP-COm softwaré from 2014 used fw1.59 (fw 1.45 1.59 come with the same pcb). VAUX-COm version, Romanian and German version of OP-COM used fw1.60. So the différence it is nót in the firmwaré as 1.44, 1.45, the difference it is in the software version. ![]() As long ás the wiTECH VCl POD is connécted to the cár (it gets powér from t.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |